VERITAS NetBackup Guía para resolver problemas descargar pdf (Pagina 289)

Appendix C, Robotic Test Utilities 277

Robotic Tests on Windows NT/2000

If the robot has been configured (that is, added to the Media Manager device database),

start the robotic test utility by using the robtest command. This saves time, since robotic

and drive device paths are passed to the test utility automatically. The procedure is as

follows:

1. Execute the following command:

install_path\Volmgr\bin\robtest.exe

The test utility menu appears.

2. Select a robot and press Enter.

The test starts.

Note If the robot is not configured, you cannot use robtest and must execute the

command that applies to the robot you are testing (see below). However, in the case

of an RSM robot, the robot must be configured under NetBackup before a test can be

run. When the RSM robot has been configured, use the robtest command as

described above.

ACS

install_path\Volmgr\bin\acstest -r ACSLS_HOST

TL4

install_path\Volmgr\bin\tl4test -r roboticpath

TL8

install_path\Volmgr\bin\tl8test -r roboticpath

TLD

install_path\Volmgr\bin\tldtest -r roboticpath

TLH

install_path\Volmgr\bin\tlhtest -r robotic_library_name

TS8

install_path\Volmgr\bin\ts8test -r roboticpath

TSD

install_path\Volmgr\bin\tsdtest -r roboticpath

1 2 ... 284 285 286 287 288 289 290 291 292 293 294 ... 321 322

Sin comentarios

VERITAS NetBackup Guía para resolver problemas Pagina 289